A/C Compressors: No broken cases or mounts, turns and pumps, no burned or broken clutch, no damaged ports, no broken plugs.

Alternators: Complete with no broken or cracked housings, no broken case fins, no broken plugs or battery posts, no broken pulley, no melted plastics or burned units.

Starters: Complete, no broken or cracked housings, no broken plugs or battery posts, no broken solenoids, no burned units, drive gear rotates freely.

Brake Calipers: Complete with bracket attached, rear calipers must have all levers and springs, no damaged castings, no missing pistons. Calipers cannot be rusted, pitted or corroded.

P/S Pumps: No broken or cracked mounts or case, turns and pumps, complete with pulley and integral reservoir, no damaged ports, no broken sensors (if applicable).

ECMs: No dents, clean & clear id labels, no broken plugs, no bent pins.

MAFs: No cracked housings, clean & clear id labels, no broken plugs, no missing or broken sensors, no missing or broken sensor wires, no missing or broken screens.

Racks: No cracked housings, no broken plugs, no missing or broken sensors (if applicable), no bent or cut main lines, no missing or bent inner tie rods, no twisted or bent input shaft.

Steering Boxes: No cracked housings, no twisted or damaged input or output shafts.

Hydrovacs: No cracked housings or mounts.  No missing accumulators. No broken or bent rods

Boosters: No dents, clean & clear id labels, no bent or broken mounting bolts, complete with rod, no broken plastic hubs.

Brake Master Cylinders: No cracked housings, no missing pistons, no damaged outlet ports, complete with reservoir, no missing or broken sensors (if applicable).

Transmissions: No cracked housings, no broken plugs or sensors (if applicable), turns freely, no twisted input or output shafts. Deductions will be taken for missing torque converters.

Distributors: No cracked housing or mounts, no twisted or damaged drive gear, no broken plugs, no cut or damaged wiring harness (if applicable).

Turbochargers / Superchargers: No shaft play, must spin freely and be complete.

 

Speedometers: No broken or cracked tabs/housing.

 

Fuel Injectors: Must have harness and no cut wires

 

Questions about your bid please call the

Phoenix Automotive Cores Customer Support Center at:

 

1-877-749-2673 / 602-314-2880

For all cores it is important that they have NO Corrosion!

When filling out your PAC-Cores invoice,

please note the following requirements for cores:

Additionally please note the conditions for each type of core: